ModeltrainsUK at Cravenmodels

Model Railway Accessories – UK and Continental Railways

Tel: 01588 660 580 www.modeltrainsuk.com email: cravenmodels@btconnect.com

BERKO OO GAUGE - ASSEMBLED COLOUR LIGHT SIGNALS CATALOGUE

ECKON and BERKO SIGNALS ARE MANUFACTURED BY THE SAME COMPANY

For ECKON KIT SIGNALS <<<< Click here

N GAUGE - BERKO ASSEMBLED COLOUR LIGHT SIGNALS <<<< Click here

<< CLICK TO ORDER, BUY & PAY

↓ FULL BERKO “OO” SIGNAL CATALOGUE & WIRING SHOWN BELOW ↓

Please do NOT use a HORNBY TYPE CONTROLLER to power these signals.

LOW POWER 12v DC ONLY Required. Power supply below.

Fixed Voltage Regulated Mains Adaptor 230v AC to 12V DC 500mA Supply CM-MG81C £13.39 plus P & P If you are using this transformer to power Model Signals you do NOT need any of the standard fittings provided. So cut off the fitting at the end of the Transformer wire – First noting which is positive or negative. Then follow the wiring diagrams shown below. If in any doubt contact your local electrician or electronics engineer.

These items are delicate electrical / electronic components that need to be connected to the correct power supply and switching device as specified by the manufacturer.

The BERKO Signals are ready assembled but must be installed correctly - The correct Polarity must be used at all times.

These products are not toys and Children need to be supervised by an adult at all times.

Eckon/Berko  -  ENB1

OO Scale

Eckon/Berko  -  ENB223

OO Scale

Signal Road Offset Yellow/Green 2Aspect

Eckon/Berko  -  ENB228

OO Scale

Signal Single Home Red/Green 12v DC

Eckon/Berko  -  ENB232

OO Scale

Signal Standard Red/Yellow 2 Light

Eckon/Berko  -  ENB242

OO Scale

Signal Single Road Offset Red/Green 2Aspect

Eckon/Berko  -  ENB251

OO Scale

Signal Single Distant Yellow/Green 12v DC

Eckon/Berko  -  ENB3

All Scales

5V 3mm Clear Bulb Short. Wires (Pack of 1)

Eckon/Berko  -  ENB301

OO Scale

Signal Red/Green Starter 2 Light

Eckon/Berko  -  ENB303

OO Scale

Signal Island Platform Starter Red/Green. 12v DC

SORRY – THIS ITEM IS NO LONGER MANUFACTURED AND IS THEREFORE NOT AVAILABLE.

Have a look at www.cravenmodels.com/ECKON.htm << Click and have a look at Signal Yoke ENEA10

Eckon/Berko  -  ENB30L

OO Scale

Short Post Offset Starter 2 Aspect L/H 12v DC

Starter signal to be used from the end of a station platform – Short Post Platform mounted.

Mounted on a bracket so that a stationery train driver can see it with ease.

Eckon/Berko  -  ENB30R

OO Scale

Short Post Offset Starter 2 Aspect R/H

Starter signal to be used from the end of a station platform – Short Post Platform mounted.

Mounted on a bracket so that a stationery train driver can see it with ease.

WITH CLIPPED EARS

NOT ROUNDED TOPS

Eckon/Berko  -  ENB362 12v DC

OO Scale

2 Light R/G Twin Head Platform Starter

Starter signal to be used from the end of a station platform – Short Post Platform mounted.

Mounted on a bracket so that a stationery train driver can see it with ease.

Eckon/Berko  -  ENB4

All Scales

5V Bulbs for EL8 (Pack of 1)

Eckon/Berko  -  ENB401

OO Scale

T Junction Yellow/Green

A signal used as a possible caution to slow down a train before a junction ahead.

Eckon/Berko  -  ENB462

OO Scale

Signal T Junction Red/Green 12v DC

A signal used as a STOP or GO before a junction ahead.

Eckon/Berko  -  ENB5

All Scales

12V Bulb Long Leads (Pack of 1)

Eckon/Berko  -  ENB503

OO Scale

Single Road 3 Light 12v DC

STOP or GO or proceed with caution on a Yellow aspect showing. The next signal might be on Red.

Eckon/Berko  -  ENB533

OO Scale

T Junction 3 Light

Junction ahead - STOP or GO or proceed with caution on a Yellow aspect showing. The next signal might be on Red.

Eckon/Berko  -  ENB551

OO Scale

Single Road 3 Aspect Offset Red/Green/Yellow 12v DC

Eckon/Berko  -  ENB6

All Scales

12V 3mm Clear Bulb Short Wires (Pack of 1)

Eckon/Berko  -  ENB604

OO Scale

Single Road 4 Light 12v DC

Red is STOP. Green is GO. One Yellow is proceed with caution as the next signal along the line might be red when you reach it.

Two yellow’s mean proceed with caution as the next two signals might be at red or two yellows when you reach them.

	Eckon/Berko  -  ENB664 OO Scale Single Road 4 Aspect Offset Red/Green/2 Yellow

Eckon/Berko  -  ENB644

OO Scale

T Junction 4 Light 12v DC

Junction immediately ahead - Red is STOP. Green is GO. One Yellow is proceed with caution as the next signal along the line might be red when you reach it.

Two yellow’s mean proceed with caution as the next two signals might be at red when you reach them.

Eckon/Berko  -  ENB801

OO Scale

GROUND 3 Light Signal 12v DC GREEN YELLOW RED

NEW MAY 2009

Berko and Eckon Kit Accessories

Eckon/Berko  -  ENEA1

OO Scale

Ladder Strip

Eckon/Berko  -  ENEA10

OO Scale

Offset 2 'T 'Junction Arm

Eckon/Berko  -  ENEA11

OO Scale

Overtrack Smoke Hoods

Eckon/Berko  -  ENEA12

OO Scale

Handwheels 6mm 6 Spoke

Eckon/Berko  -  ENEA2

N Scale

Ladderstrip

HIGH DEGREE OF SKILL NEEDED >>

Eckon/Berko  -  ENEA3

OO Scale

L/H Route Indicating Head kit 12v DC

To fit this kit to an eckon signal kit, just glue the curved base onto the top rear of the signal head and pass the wires down the signal post as normal.

Then follow the wiring instructions provided with the kit.

A maximum of only 2 FEATHERS can be fitted in a Y configeration, onto one signal due to the size of the curved base of the kits.

To fit 2 feathers, you put a left on the right and the right on the left - You will have to remove one small part of each curved leg very carefully. Skill is needed.

HIGH DEGREE OF SKILL NEEDED >>

Eckon/Berko  -  ENEA4

OO Scale

R/H Route Indicating Head kit 12v DC

To fit this kit to an eckon signal kit, just glue the curved base onto the top rear of the signal head and pass the wires down the signal post as normal.

Then follow the wiring instructions provided with the kit.

A maximum of only 2 FEATHERS can be fitted in a Y configeration, onto one signal due to the size of the curved base of the kits.

To fit 2 feathers, you put a left on the right and the right on the left - You will have to remove one small part of each curved leg very carefully. Skill is needed.

Eckon/Berko  -  ENEA5

OO Scale

Lineside Fog Signalling Apparatus & Hut

SORRY THIS ITEM HAS BEEN DISCONTINUED BY THE MANUFACTURER - SEE ITEM BELOW

Eckon/Berko  -  ENEA6

OO Scale

Fogmans Huts (3)

Eckon/Berko  -  ENEA7

OO Scale

Speed Restriction Sign Fret – Speed restriction signs mounted on short poles at the side of the track.

Eckon/Berko  -  ENEE1

All Scales

On/Off Switch (Green)

Eckon/Berko  -  ENEE2

All Scales

2 Way Centre Off Switch

Eckon/Berko  -  

All Scales

3 Way Lever Switch

Eckon/Berko  -  ENEE4
OO/ N Scales	New 2008
Lectralock Lever Switch Passing Contact

Eckon/Berko  -  ENEET
OO/ N Scales	New 2008
8ba Nickel Silver Solder Tags to attach wires to Lever Switches
Now released

Eckon Colour Light Signal Kits and Yard Lighting Kits << JUST CLICK

TRAINTRONICS GANTRY MOUNTED SIGNAL HEADS << Just Click

102HEAD ONLY	2-Aspect Red/Green c/w Fading Interface Board – HEAD ONLY – NO POST OR LADDER Just Head for Gantry Mounting with long lead wires and PCB
103HEAD ONLY	2-Aspect Yellow/Green c/w Fading Interface Board – HEAD ONLY – NO POST OR LADDER ust Head for Gantry Mounting with long lead wires and PCB
104HEAD ONLY	3-Aspect Red/Yellow/Green c/w Fading Interface Board – HEAD ONLY – NO POST OR LADDER Just Head for Gantry Mounting with long lead wires and PCB
105HEAD ONLY	3-Aspect Yellow/Green/Yellow c/w Fading Interface Board – HEAD ONLY – NO POST OR LADDER
107 HEAD ONLY	4-Aspect Red/Yellow/Green/Yellow c/w Fading Interface Board

181	Steam Era 4 Track Gantry Kit (Signal heads not included) OO Brass – Needs to be assembled by soldering

CANTILEVER SIGNAL GANTRIES – PLASTIC KITS

MODELTRAINSUK - www.modeltrainsuk.co.uk << Click for more details

DOUBLE CANTILEVER TRACK SIGNAL PLATFORM OR SINGLE TRACK CANTILEVER SIGNAL

Modeltrainsuk at Cravenmodels 4 Track